High On Life 2 Guide | How to Disable Hall H Security

Turn off the defenses in Hall H by using Lugblobs, Power Panels, and Sweezy during Kill Senator Muppy Doo.

Game Guide by Ornstein on Feb 16, 2026

While trying to finish the main mission Kill Senator Muppy Doo, you will run into this puzzle. The security system keeps Senator Muppy Doo from getting a clear shot, so the room needs to be set up right before the fight can start.

With two lugblobs, you can open the door to Hall H.

High On Life 2, PC, Gameplay, How to Disable Hall H Security, Screenshot, NoobFeed

The entrance to Hall H is connected to a locked door in the maintenance area, so you can't even get in. There are two inactive Power Panels in that room, close to the door wiring. You need to put two Lugblobs on those panels for the wires to turn green and the door to open.

To get to the Upper Room, use Balloons, Sweezy, and a Lugblob.

High On Life 2, PC, Gameplay, How to Disable Hall H Security, Screenshot, NoobFeed

The talk is already going on inside Hall H, but the defenses stay up until the right power route is finished. The way forward is up. The inflatable balloons work like jump pads, so if you stay on that path, you won't get lost and will get to the room above.

Using Sweezy on a Lugblob is a big part of this. Use Sweezy's time bubble to blow up the Lugblob, then use it as a platform to get to the top. This is the step that usually makes the puzzle work.

High On Life 2, PC, Gameplay, How to Disable Hall H Security, Screenshot, NoobFeed

Put Both Lugblobs in Place to Turn Off Security

When you get to the top room, pick up the second Lugblob and go back down the same way you came. Go back to the first room and put both Lugblobs on the Power Panels that they are supposed to be on. When both panels are turned on, Hall H security goes off, and Senator Muppy Doo is open to attack.

High On Life 2, PC, Gameplay, How to Disable Hall H Security, Screenshot, NoobFeed

The most common reason why the security won't turn off is that one Lugblob is a little off the panel. Re-center it until the panel clearly shows that it is on, and then check the wiring state again before moving on.

Also, check our High On Life 2 Review and other guides below: